Microscan QX Hawk Manual do Utilizador descarregar pdf (Página 306)

7-24 QX Hawk Industrial Imager User Manual

Default/Reset/Save

Customer Default Parameters

Customer default parameters (saved by <Zc>) are the same set of parameters as power-on

parameters but are saved in a different, isolated section of NOVRAM. This allows a user

essentially to create a back-up set of parameters that can be recalled in the event that the

current parameters or power-on parameters have been accidentally changed or are no

longer desired.

It is important to note that a hardware default (jumper the default pin to ground) does not

affect customer default parameters. For example, a user that has inadvertently changed

communication settings and saved them with a <Z> command, may not know the correct

settings or have the capability to communicate within those settings. By first doing an EZ

Button default to restore the known Microscan

defaults, the user can then recall the previous

customer-saved

settings with an <Arc> or <Zrc> command.

Restore Customer Defaults

Use the EZ Button to default the scanner by holding it down while applying power to the

scanner (if this feature is enabled).

Microscan Default Parameters

Microscan default parameters are contained in the firmware and cannot be changed.

Software Defaults

Microscan default parameters can be recalled (loaded into current settings) with the

<Ard> command or recalled and saved for power-on with the <Zrd> command.

Hardware Default

If a software default and reset is not possible, it may be necessary to reset the imager by

shorting (connecting) specific pins. This procedure has the same effect as the <Zrd>

software command.

Important: For this reset to occur, this command must be executed within 60 seconds of a

power-on or a reset.

1. Apply power to the imager.

2. Locate default pin and ground. Ensure that the correct pins are located, as connecting

the wrong pins may cause serious damage to the imager.

3. Momentarily connect the wires (or pins) and listen for a series of short beeps that last

approximately 3 seconds.

4. Within 3 seconds, disconnect and then re-connect the two wires again. A longer beep

should be heard. If not, repeat the process above.

Default on Power-On

Use the EZ Button to default the imager by holding it down while applying power to the

imager (if this feature is enabled).

1 2 ... 301 302 303 304 305 306 307 308 309 310 311 ... 459 460

Sem comentários

Microscan QX Hawk Manual do Utilizador Página 306