Microscan MS-4X Manual do Utilizador descarregar pdf (Página 126)

Autocalibration by Embedded Menu

6-12 MS-880 Industrial Long Range Scanner User’s Manual

6–Autocalibration

Advanced Autocalibration Setup Embedded Menu

The Advanced Autocalibration Setup menu allows you to change the starting focus

position and the number of focus steps during the first pass.

For example, if you are preparing to do autocalibration on labels whose minimum dis-

tances from the scanner is 40 inches, there is no reason for autocalibration to cycle

through all of the focal positions inside 40 inches. Figure 6-7 includes a table that

associates several starting focus positions with minimum label distances from the

scanner. Use this table to estimate your starting focus position.

To increase Starting Focus Position, type T. To decrease it, type R.

To increase the First Pass Focus Step, type G. To decrease it, type F.

Increasing First Pass Focus Step will speed up the autofocus process, but can also

cause autofocus to skip over a bar code symbol and not decode it.

Note: All single letter commands must be entered in upper case.

Auto Range is disabled by default. To enable, press A. See page 6-6 for an explana-

tion of auto range.

Figure 6-7 Advanced Autocalibration Menu

1 2 ... 121 122 123 124 125 126 127 128 129 130 131 ... 311 312

Sem comentários

Microscan MS-4X Manual do Utilizador Página 126