Microscan MS-4X Manual do Utilizador descarregar pdf (Página 225)

Chapter 15 Diagnostics

MS-880 Industrial Long Range Scanner User’s Manual 15-7

15–Diagnostics

NOVRAM Corrupt Warning Status

When enabled, a 7 character message is sent whenever the system detects a warning

condition.

Important Note: Warning Corrupt Message Status must be enabled before the

NOVRAM message in this menu can be transmitted

Warning messages for NOVRAM can appear in one of five formats:

<NVRAM-C>

This message indicates an error in user settings. The message repeats once every 30

minutes. If this message is received, restore customer settings and send a <Z> com-

mand.

If the condition persists, call customer service.

<NVBAD-D>

Indicates that diagnostic lifetime hours, power-on counts, and reset counts have been

lost. The message repeats once every 30 minutes. (Contact Microscan Service.)

<NVBAD-L>

Indicates a problem with laser current factory reference. The message repeats once

every 30 minutes. (Contact Microscan Service.)

<DFALT-C>

Indicates that the customer NOVRAM settings have been defaulted either by a cus-

tomer initiated default or by a problem with the scanner. This message is sent ONLY

ONCE.

<DFALT-F>

Indicates that the factory NOVRAM settings have been defaulted. This message is sent

ONLY ONCE upon reset. (Contact Microscan Service.)

Function: When enabled, a 7 character message is sent whenever the system

detects a warning condition.

However, if you suspect that erroneous defaults are occurring, enable

NOVRAM Messages by sending <K400,1,,,1>. This will allow the

NOVRAM messages, if present, to be viewed.

Usage: Alerts the user to NOVRAM failure. (Contact Microscan Service.)

Serial Cmd: <K400,warning message status,laser high status,laser low status,

novram reset warning status>

Default: Disabled

Options: 0 = Disabled

1 = Enabled

1 2 ... 220 221 222 223 224 225 226 227 228 229 230 ... 311 312

Sem comentários

Microscan MS-4X Manual do Utilizador Página 225