Microscan MS-4X Manual do Utilizador descarregar pdf (Página 47)

Chapter 2 Communications

MS-880 Industrial Long Range Scanner User’s Manual 2-17

2–Communications

Daisy Chain Remote Scanner ID

Note: Scanner IDs can also be assigned in “Daisy Chain Mode” on page 2-20.

Daisy Chain Scanner Number

Daisy Chain Scanner ID

Note: After a slave scanner accepts a new ID, it automatically invokes a reset-with-

save command.

Definition: Assigns a new daisy chain ID to a daisy chain scanner. The command is

sent to the master scanner to configure the other scanners.

Usage: This command provides a handy way to assign custom daisy chain IDs

to specific scanners that were assigned during the daisy chain autocon-

figure process.

Serial Cmd: <K151,daisy chain scanner #,scanner ID>

Definition: Specifies the target scanner (by sequential number) which will be

receiving the new Daisy Chain ID. The master scanner is always 0

(zero). All slave scanners are numbered 1...n in the order that they are

connected.

Note: These numbers are for assigning IDs only and are not

changeable.

Serial Cmd: <K151,daisy chain scanner #,scanner ID>

Options: 1....n (0 for the master scanner)

Definition: A two-character user-defined ASCII message identifying a scanner in

the daisy chain.

Serial Cmd: <K151,daisy chain scanner #,scanner ID>

Default: Sequential numbering of scanner units resulting from the Daisy Chain

Auto-configure <K150> command; for example: ID Master = 1/;

ID Scanner 1 = 2/; ID Scanner 2 = 3/; etc.

Options: Any two characters except , < > NUL.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 311 312

Sem comentários

Microscan MS-4X Manual do Utilizador Página 47